Whirlpool ADVANTECH CL-8 - Manual (Page 39)

ADVANTECH ™ Management Software Setup
30
New Washer Template options, defaults are listed below the option:
Option Description
Estimated Fill Time
(0 seconds)
Estimates the time it takes to fill a machine during wash or
rinse cycles. This time is added to the
Base Cycle Time. An
estimated fill time can be obtained from the audit results by
location. Display time will be increased by double the amount
selected as it adds the time to both fill cycles.
Extra Money for
Warm Water
($0.00)
Indicates how much money to be added to the Base Cycle
Price when warm water is selected.
Extra Money for Hot
Water
($0.00)
Indicates how much money to be added to the Base Cycle
Price when hot water is selected.
Hot Temperature
Reduction
(0) Indicates how many seconds of cold water should be added
to the hot water for each minute of fill time. Max of 30
seconds.
Enable Warm Rinse
(No) Selects warm water only for the Rinse Cycle. The default is
No (no check mark).
Is Pressure Switch
Set to Low Level (No)
Indicates whether washer’s pressure switch is set to low.
The default is No (no check mark). See Service Tech
Manual for more information.
Freeze Time During
Fill (No)
Indicates whether machine’s Base Cycle Time should begin
counting down during machine fill. The default is No (no
check mark).
New Dryer Template options:
Option Description
Topoff Price
($0.00) Indicates that Base Cycle Time can be extended after the
initial Base Cycle Price has been met.
Topoff Time
(0) Sets the amount of time, in minutes, that is added for each
additional coin.
Disable Topoffs Does not allow Topoffs.
Extended Cooldown
(5 minutes)
Indicates the number of minutes of Cooldown before end of
the Base Cycle Time. This is part of the Base Cycle Time,
not an addition to.
5. Click on Save to save machine
template options.
6. A number will automatically be assigned to the
template. Click on OK to confirm the action.