Westell Technologies Router 2400 - Manual (Page 105)

030-300331 Rev. A 103 October 2002
4-Port Router (Model 2400) User Guide
belongs to your local network.
DHCP Start Address (If
DHCP is enabled for
Public LAN) This setting specifies the start of the IP address pool that the modem uses to
assign IP addresses to local devices.
DHCP End Address (If
DHCP is enabled for
Public LAN) This setting specifies the end address of the IP address pool used for automatic
configuration of local devices.
DHCP Lease (If DHCP is
enabled for Public LAN) This setting specifies the DHCP lease time.
S
Software Upgrade
Software Upgrade
Software Upgrade This screen is used to upgrade the Router’s application image. The application
image is specified by entering in the filename or by use of the browse button.
Single Static IP
This page contains the settings that would allow the PPP address received from the network to be propagated to a
single LAN device behind the modem.
Single Static IP
WAN IP Address This is the PPP IP address the ISP has assigned the modem.
Selection box This box contains the devices available to share the Single Static IP address the
ISP has assigned the modem. The names listed in the select box will be
populated by the modem’s DHCP server based on DHCP requests. If a device’s
name cannot be determined, the current IP address of the device will be placed
in the list.
When the feature is enabled, the active machine will be highlighted in the select
box and be displayed at the bottom of the page with the “disable” button.
When the feature is disabled, no device in the select box will be highlighted and
the “enable” button will be available.
When the “User Configured PC” is selected, a local PC must be configured
manually with the WAN IP address as its Ethernet adapter’s address.