Wasp Bar Code Wasp WPL305 - Manual (Page 8)

cover.
2. Do not allow the top cover to slam closed.
3. Failure to securely close and lock the cover will result in poor print
quality.
3.7 Top Cover Operation
To Open:
1. When facing the front of the printer pull the cover release levers on both
sides of the printer towards you.
2. Lift the top gradually.
There are two stop positions for the top cover. Position 1 and 2 are
indicated on the label below.
Note: To hold the cover open at position 1, you must lift the cover
higher than the stopping point at position 1 and gently lower the
cover to stopping point 1.
Do not let the cover free fall!
3. Fully open the top cover and gently lower it to stop position 2.
Figure 7: Top cover support is fixed at position 2
4. To close the cover, lift up the top cover to the ultimate angle then close the
top cover gently and it will be kept at a stop position between 1 and 2 for a
while. The cover will close automatically after several minutes. If you want
to speed the closing, use both hands to gently push down the top cover to
close it and make sure the cover is latched on both sides.
Note: Do not place your hands between top cover and lower cover
6