Wasp Bar Code Wasp WPL305 - Manual (Page 4)

2.3 Printer Parts
Ribbon Access Window
Top Cover Open Lever
Feed Button
Printer Top Cover
LED Indicator
Figure 1: Top front view
3. Setup
3.1 Setting Up the Printer
1. Place the printer on a flat, secure surface.
2. Make sure the power switch is off.
3. Connect the printer to the computer with the Centronics or USB cable.
4. Plug the power cord into the power supply connector at the rear of the
printer, and then plug the power cord into a properly grounded
receptable.
Rear Paper Guides
Wall
Plug
Power Supply
Figure 2: Back of Printer Parts
Centronics
/ Parallel
RS-23 USB Power Power Switch
2