Wolf Appliance Company High Definition Video Processor DCL-200FD - Manual (Page 29)

28
B. Using Auto Search Method
Step 1] Turn on the Device you want to operate manually.
Step 2] Press the Source Device Input button and the OK buttons simultaneously and hold for 3 seconds until the
Device LED turns on. (The LED will stay on for 20 seconds. The next step must be entered during this period).
Step 3] Point the remote control toward the Device and press the Cursor + (or Cursor -) button one at a time (or keep it
at pressed) until turn of the Device.
Tip: Each the Cursor + (or Cursor -) button sends the Power signal of one Setup Code number.
Tip: Once the Device turns off, you are able to test other functions by pressing the buttons except the Device, Cursor+/-,
Number 0-9 and Light buttons. Power On, Off, MUTE and Volume and Channel number buttons (0-9). (The Device button
LED will blink once for each button pressed).
Step 4] Once your Device turns off, press the Source Device Input button selected in the Step 2 once again to store
the Setup Code number. (The Device LED will blink three times to confirm that the code has been stored).
Step 5] Repeat the above steps to program the remote control for each of other Devices.
Tip: You are able to go back to the Using Three Digit Code Method mode by pressing the Channel number buttons (0-9)
the OK button in the Step 3.
Tip: If you are still missing the Setup Code numbers to control any of your devices, use the Learning Method on the next page.
C. Programming a Second DVD, etc. to Other Device Buttons
This feature is used to program the remote control for two or more DVDs, etc., or to program a device into other device
buttons. You can program the Setup Code number for any Device into any other unused Source Device Input button.
Example: If you have two DVD players. First, using the DVD button, program the remote via standard setup to operate
the first DVD player. Then, program your second DVD into a Source Device Input button that is not being used, e.g., AUX
using this method.
Step 1] Turn on the DVD player manually.
Step 2] Press the AUX button and the OK buttons simultaneously and hold for 3 seconds until the AUX LED turns on.
(The AUX device LED will stay on for 20 seconds. The next step must be entered during this period).
Step 3] Press the DVD button to program the DVD's Setup Code numbers.
Step 4] Point the remote control toward the DVD player and press in the first three-digit Setup Code number for that Device
using the number buttons(0-9) on the remote control. (The DVD Device LED will blink once for each button pressed).
Tip: Your DVD player will turn off when the corrected Setup code number has been selected. If the DVD does not turn off,
press in the next Setup Code numbers until your DVD turns off.
Step 5] Once your Device turns off, press the AUX button once again to store the Setup Code number. (The AUX Device
LED will blink three times to confirm that the code has been stored).
D. Finding the Setup Code number that was stored in the Device
Step 1] Press the Source Device Input button you wish to verify and the OK buttons simultaneously and hold for 3
seconds until the Device LED turns on. (The LED will stay on for 20 seconds. The next step must be entered
during this period).
ProScaler
High Definition Video Processor User’s Manual