Wayne-Dalton LIGHT COMMERCIAL DOOR 6100 User Manual
Page 13
13
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
iNST
alla
Tio
N
Top Section
Place the top section in the opening and vertically
align with lower sections.
Temporarily secure the top section by driving a nail in
the header near the center of the door and bending
it over the top section. Now flip up hinge leaf against
section, fastening center hinges first, and end hinges
last. (Refer to Step 6).
When installing a door with a Torquemaster
®
Plus
counterbalance system, vertical track alignment is
critical. Position flagangle between 1-11/16” (43 mm)
to 1-3/4” (44 mm) from the edge of the door. Tighten
the bottom lag screw. Flagangles must be parallel to
the door sections.
Repeat for opposite side.
imPoRTaNT: ThE DIMENSION bETWEEN ThE
FLAGANGLES MUST bE DOOR WIDTh PLUS 3-3/8”
(86MM) TO 3-1/2” (89 MM) FOR SMOOTh, SAFE
DOOR OPERATION.
Complete the vertical track installation by securing
the center jamb bracket(s) and tightening the other
lag screws. Push the vertical track against the rollers
so that the rollers are touching the deepest part of
the curved side of the track (see illustration); tighten
all the track bolts and nuts.
Repeat for opposite side.
hammer
Tape Measure
Power Drill
7/16” Socket Driver
Step Ladder
Flagangle
Top
Section
Nail
Top section
Door width
+3-3/8” to 3-1/2”
10
1-11/16”
To 1-3/4”
Roller against
vertical track