Wayne-Dalton TELEPORT WDHC-20 - Manual (Page 18)

18
1. On Teleport™ press and hold SETUP until the
last-selected mode key blinks twice.
2. Enter 995 on the numeric keypad. The
last-selected mode key blinks twice.
3. Select a macro key, for example, the number 1
on the numeric key pad, and press it once.
4. Press the key sequence you want to program
into the macro. For example, to turn on your TV
and raise its volume, press TV followed by VOL+.
NOTE: You can program up to 15 key presses into
one macro.
5. Press and hold SETUP until the last-selected
mode key blinks twice.
6. To add another macro, repeat Steps 1 - 5,
substituting the new key sequence to be added in
Step 4.
Programming a Macro Key
NOTE: Programming more than 5 macros on the same
macro key overwrites previous settings.
1. On Teleport™ press and hold SETUP until the
last-selected mode key blinks twice.
2. Enter 995 on the numeric keypad. The
last-selected mode key blinks twice.
3. Press the macro key you want to clear once.
4. Press and hold SETUP until The last-selected
mode key blinks twice.
Clearing a Macro Key
MACRO KEY BASICS
The Teleport™ remote control includes a macro key
feature. Macro keys allow you to create small programs
which activate a series of key presses in a specific
order(sequence of commands.) For example, you can set
up a macro to do the following set of actions with a single
key press: change the channel on your TV, start playing a
DVD and dim the lights.
NOTE: Any previously-programmed macro key must be
cleared before it can be changed, see “Clearing a Macro
Key” below.
This macro key is now clear and ready for re-programming. To
re-program, see “Programming a Macro Key” above.