White Rodgers 1F94W-71 - Manual (Page 35)

35
To correct this, remove the thermostat from
the wall and remove the battery for at least
two minutes. After reinstalling the battery,
the thermostat will revert to the factory pre-
set program until you reprogram the ther-
mostat. If you don’t want to reprogram the
thermostat immediately, press SYSTEM
HEAT/EMER/OFF/
COOL/AUTO
until
OFF is displayed and replace the thermo-
stat on the wall. Then press RUN
PRGM
to begin
the factory preset program.
To prevent further static discharge prob-
lems, touch another object to release static
build-up before touching the thermostat.
See OPERATING YOUR THERMOSTAT.
7. Why won’t the setpoint temperature go
to the temperature I want?
In the AUTO mode, the highest heating
setpoint temperature you select must be at
least 1
°
F lower than the lowest cooling
setpoint temperature you select (for ex-
ample, if 70
°
F is your lowest selected cool-
ing temperature, you cannot select a heat-
ing temperature any higher than 68
°
F). If
such a conflict exists, set the lowest cooling
temperature higher in order to set the heat-
ing temperature higher. To set a lower cool-
ing temperature, you must select a lower
heating temperature. See PROGRAMMING
YOUR THERMOSTAT.