Wintal DVDRX160 User Manual

Page 31

When your DVDRX160 is turned on, the system will start in Tuner
mode. Th

e timeshift buﬀ er will start recording. If the timeshift buﬀ er

mode is set to refresh (See System Setup) and you change channels,
the timeshift buﬀ er will be lost. No message will be provided prior to
doing so. However if the timeshift buﬀ er is set to “PRESERVE” the time
shifting buﬀ er will be maintained.

Note: If you change the input source and the video standard is diﬀ erent
(NTSC vs PAL), the timeshifting buﬀ er will be erased.
During timeshifting, a Timer recording (pre-programmed recording)
may come up. As you can not watch one program in Timeshifting and
record another channel, the DVDRX160 will ask you to conﬁ rm if you
want to keep the current channel or proceed with Timer recording. If
there is no response, the unit will assume Timer recording should start.
Th

e message will appear 2 minutes before the timer recording is due.

SAVE
In order to save part or all of the timeshifting buﬀ er, two options are available:

Save Option 1
While viewing a program using timeshift, press REC, this will mark the start of the segment to be recorded.
You can navigate forward and back using the “transport” keys. By pressing REC, you will increase the length of the program you are
saving by 30 minutes, up to a mmaximum of 3 hours. Press stop to indicate the end of the segment to record. Th

e save part of the

timeshifting buﬀ er will be tagged in RED.

Save Option 2
While viewing a program, press Rec and hold down for 3 seconds. Th

is will save the entire Time shifting buﬀ er. If Stop is pressed, the

save will terminate at that point in the buﬀ er. Press Stop and hold for 3 seconds if you want to cancel the save operation.

Note: You cannot change the channel or source while in the process of saving (the end of the recording segment is either not
entered, or in case of a long recording, it has not been reached). Saving has to be manually stopped ﬁ rst (by pressing STOP ). Th

segment will be Saved on HDD and then channel or source change can be performed.

Note: Only one segment in the Time shifting buﬀ er can be identiﬁ ed for Saving. It is not possible to identify multiple segments.
Once the segment has been Saved and registered on the Title list, this segment will be removed from the Time shifting buﬀ er.