VIEWSONIC PJD5233 - Manual (Page 23)

Operation
Powering On/Off the Projector
Powering On the Projector:
1. Complete the AC power cord and peripheral signal cable(s) connections.
2. Press to turn on the projector.
The projector takes a minute or so to warm up.
3. Turn on your source (computer, notebook, DVD, etc.). The projector
automatically detects your source.
„ If you are connecting multiple sources to the projector simultaneously, press
SOURCE on the projector or Source on the remote control to select your
desired signal or press your desired signal key on the remote control.
Warning
„ Never look into the lens when the lamp is on. This can damage your eyes.
„ This focal point concentrates high temperature. Do not place any object near
it to avoid possible fire hazard.
Powering Off the Projector:
1. Press to turn off the projector lamp. You will see a message "Power off?
Press Power again" appear on the screen.
2. Press again to confirm.
„ The cooling fans continue to operate for cooling cycle.
„ When green mode is turned off, the Power LED begins flashing and the
projector has entered stand-by mode.
„ When green mode is turned on, the Power LED becomes steady light and the
projector has entered stand-by mode.
„ If you want to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered stand-by mode. Once in stand-
by mode, simply press to restart the projector.
3. Disconnect the AC power cord from the electrical outlet and the projector.
4. Do not turn on the projector right after power off.
20