VIEWSONIC PJD5233 - Manual (Page 20)

Connecting Video source devices
You can connect your projector to various Video source devices that provide any one
of the following output sockets:
„ HDMI
„ Component Video
„ S-Video
„ Video (composite)
You need only connect the projector to a Video source device using just one of the
above
!connecting methods, however each provides a different level of video quality.
The method !you choose will most likely depend upon the availability of matching
terminals on both the !projector and the Video source device as described below:
Connecting an HDMI source device
Examine your Video source device to determine if it has a set of unused HDMI output
jacks available:
„ If so, you can continue with this procedure.
„ If not, you will need to reassess which method you can use to connect to the
device.
To connect the projector to an HDMI source device:
1. Take an HDMI cable and connect one end to the HDMI output jack of the HDMI
source device.
2. Connect the other end of the HDMI cable to the HDMI jack on the projector.
Terminal name Terminal appearance Reference Picture quality
HDMI
HDMI “Connecting an HDMI
source device” on
page 17
Best
Component Video
COMPUTER “Connecting a
Component Video
source device” on
page 18
Better
S-Video
S-VIDEO “Connecting an S-
Video source device”
on page 18
Good
Video
VIDEO “Connecting a
composite Video
source device” on
page 19
Normal
17