Viking F20533 EN - Manual (Page 13)

24 25
1 2
Reattach door to range. Open door completely. Reattach hinge trim.
3 4
Remove pins from holes in hinges. Close door.
5
If the door needs to be adjusted, loosen hinge trim screws located in
step 2. Adjust the screws located between the door and kickplate using a
5/32” hex head allen wrench. After adjustment, tighten hinge trim screws.
Door Replacement and Adjustment
1 2
Burner caps are packed in styrofoam top pack with the
grates. Place burner on top of range. Place burner
grate on top of burner cap and grate support.
Note: Arrow on burner cap must be pointing towards
back of range.
3
3/8” 3/8
”
(0.95 cm) (0.9
5 c
m) 3/8”
(0.95 cm)
Check that unit is level side to side
and front to back. The side trim must be 3/8” (0.95 cm)
above countertop. If unit is not level repeat steps 5-7
of “Leveling/Adjustments/Alignment” section.
Slide range into place. Be sure
anit-tip bracket slides into the anit-tip opening.
Final Installation
1
Unscrew four standoff brackets and remove.
Standoff Bracket Removal
(48” and 60”W. VDSC Models Only)
Note: Standoff brackets can only be removed if range is installed against a NON-COMBUSTIBLE wall.
DANGER
FIRE HAZARD
Standoff brackets provide a
3/4” barrier between back of
range and rear wall. These
must be in place for adequate ventilation.
The standoff brackets may only be
removed if range is installed against a
non-combustible wall.