Operating the seal-it 100 with diagnostics, Operating the s – Velocity Micro SEAL-IT 100 User Manual
Page 37
33
Chapter 2: SEAL-IT 100
SEAL-IT 100 Device Driver User Guide
Updating the profile. Use the Update command to save edits to
an existing profile.
Copying a profile.
Renaming a profile.
Deleting a profile.
Related topics
Operating the SEAL-IT 100 with diagnostics
About this topic
This topic describes how to:
❑
Initialize the SEAL-IT 100
❑
Use the Seal and Trim commands
❑
Set parameters for the sealing operation
Read this topic if you are an operator who wants to troubleshoot or
operate the SEAL-IT 100 using direct commands.
Before you start
Before you can send commands to the SEAL-IT 100, or receive status
information from the SEAL-IT 100, you need to initialize it.
To initialize the SEAL-IT 100:
1.
Open SEAL-IT 100 Diagnostics.
2.
Click the Profiles tab.
3.
Select a profile from the
Profile name list.
4.
Click
Initialize this profile.
Sealing and
trimming a plate
The Seal command both seals the plate and cuts the seal so that the
plate can be separated from the roll.
The Trim commands cuts a length of seal from the end of the roll. You
might use this command after loading a new roll.
For more information about...
See...
Opening diagnostics
“Opening diagnostics” on page 12
The workflow for configuring the
SEAL-IT 100
“Workflow for configuring the SEAL-IT
100” on page 28
Creating a SEAL-IT 100 profile
“Creating a SEAL-IT 100 profile” on
page 29
Operating the SEAL-IT 100