VIEWSONIC CD4230 VS12541 - Manual (Page 32)

ViewSonic CD4230
30
Display-Wall
Note: This item is only available for the VGA, YPbPr and DVI inputs.
• You can tile up to 25 monitors to create a display wall. This also requires you to feed the PC output
into each of the monitors through a distributor.
• Press ENTER button to display the sub-menu:
• Matrix: Selects the matrix configuration of the display wall. Press ENTER, and then or
button to change selection.
• X.Index: Selects the horizontal position of the monitor in the display wall matrix. Press or
button to change selection.
• Y.Index: Selects the vertical position of the monitor in the display wall matrix. Press or
button to change selection.
Power save
• If turned on, the LCD monitor will go to power management mode when PC sync is lost, and will enter
power management mode when no DVD/HD or VIDEO input signal can be detected three times in a
row.
• Press ENTER, and then or button to turn this function on or off.
Set Monitor ID
• By connecting multiple LCD monitors to a PC using RS-232C cables, you can control any one monitor
or all the monitors on the PC. Assign arbitrary ID number to each of multi-connected CD4230 monitors
using this function. ID numbers 1 to 25 are selectable. It is recommended to assign sequential ID
numbers from 1 and up.
• Press ENTER, and then or button to change the ID number.
Image Retention
• If turned on, the LCD monitor automatically displays swift moving patterns to prevent the formation of
image retention on the screen.
• Press ENTER, and then or button to turn this function on or off.
NOTE: IMAGE PERSISTENCE
• Please be aware that LCD Technology may experience a phenomena known as Image Persistence.
Image Persistence occurs when residual or “ghost” image of a previous image remains visible on the
screen. Unlike CRT monitors, LCD monitors’ image persistence is not permanent, but constant
images being displayed for a long period of time should be avoided.
• To alleviate image persistence, turn off the monitor for as long as the previous image was displayed.
For example, if an image was on the monitor for one hour and a residual image remains, the monitor
should be turned off for one hour to erase the image.
• As with all personal display devices, ViewSonic recommends displaying moving images and using a
moving screen saver at regular intervals whenever the screen is idle or turning off the monitor when
not in use. Please use the Power Save and Schedule functions to further reduce the risk of Image
persistence.
Auto Adjustment
• Use this function to let the LCD monitor automatically optimize the display of PC or YPbPr input
image.
• Press ENTER button to execute this function.
Matrix 2x2
X.Index 1
Y.Index 1
Setting
:Move :Enter :Exit Enter Exit