Venturer HPS9308 - Manual (Page 79)

- 79 -
One of the most frequently used functions of this Navigator is
selecting the destination. Once you have the destination, you can
start navigating. Getting to this point should be as fast as possible.
This Navigator provides you with a versatile search engine
designed to find your chosen destination after only a few taps on
the screen.
Find 8
NOTE :
If you select a location in any part of the Find system, you will normally
drop back to the map screen, where you will have several possible
actions (set as start, set as destination, add as via, continue route with,
mark with a pin, or add as a POI item). However, if you enter the Find
system using the Find & GO button, this Navigator will immediately put
you into Cockpit mode and start navigation.
8.1 Find & GO (Main
Menu)
As just mentioned, the fastest
way to find your destination
and start navigating is to tap
Find & GO in the Main Menu
(6.1) This will put you on the
Find screen, and as soon as
you pick a destination, this
Navigator will immediately
show the Cockpit screen
and start navigation. This
means that if you plan your
route to one of your favorite
destinations, you only need
two taps to start navigating.
8.2 Selection by
Tapping the Map
It is also very easy to set your
destination using the map.
Just browse to your desired
destination on the map, tap it,
and the Cursor menu with the
possible actions will then open
automatically.
NOTE :
When appearing automatically,
the Cursor menu remains open
for a few seconds only. If you
decide not to choose any of the
actions, listed, the menu closes
automatically. When you open
it manually, it will remain until
you close it or switch to another
screen.