Venturer HPS9308 - Manual (Page 67)

- 67 -
7.4 Route Parameter
Settings
This is a very important page.
Settings here determine how
routes will be calculated. This
screen is directly accessible
from the Route Information
screen (6.6).
7.4.1 Method
Use the handle to set the speed
of the route calculation. In the
leftmost position the route
may not be optimal but the
calculation will be very fast.
Sliding it to the right will result
in more accurate routing in an
increased amount of time.
NOTE :
Since this Navigator calculates
routes very quickly, the position
of this slide is only used for long
routes. Short routes are always
calculated to give you the optimal
result independent of the slider.
7.4.2.1 Fast
Choosing Fast will result in the
quickest possible route, given
that you can travel at or near
the speed limits on all included
roads. This is usually preferred
for fast and normal cars.
7.4.2.2 Short
Choosing Short will result in a
route that has the smallest total
distance of all possible routes
between the given points. This is
usually preferred by pedestrians,
cyclists or slow vehicles.
7.4.2.3 Economical
This setting is a wise combination
of the previous two. Although
basically going for the fastest
solution, if there is another route
taking a bit more time but a lot
less distance compared to the
quickest one, this Navigator will
choose this one instead to save
fuel.
7.4.2 Route
Here you can choose from three
different route types.