VBrick Systems VBRICK APPLIANCE VB6000 - Manual (Page 59)

WM Configuration
VBrick WM Appliance Admin Guide 49
• Create – at the server level will allow a user to create publishing points, or at the
individual publishing point level it will allow a user to create
Copy From Points
.
Adding users and privileges at the server level will allow all inherited publishing points to
acquire the same security privileges. To add individual privileges for a specific publishing
point, select the
Publishing Point
, click
Properties
, select
Authorization
, and right-click
WMS Publishing Points ACL Authorization
. To add users and subsequently, permissions, the
user must already exist as a domain user or as a local user on the server. The user name will
be listed and can be given the desired privileges.
T To Create Authenticated Push Publishing Points:
On the
WMS Publishing Points ACL Authorization
screen from above, uncheck
Allow Write
Permission
for the
Everyone
user if already checked, and add write permission for a selected
user or set of users by adding the user. Click
Ok
to apply the change to the server. Only the
named users will be allowed to push to the server after being authenticated. If this change is
done at the server level, the changes must be propagated to the publishing point level to be
effective.
T To Create Non-Authenticated Push Publishing Points:
Either disable
WMS Publishing Points Authorization
, or keeping the default policy of
authorization always on, and selectively allowing authentication to be bypassed for some, on
the
WMS Publishing Points ACL Authorization
at the publishing point level, select
Allow
Write Permission
for the
Everyone
user (if already on the list or add to the list if necessary).
Click
Ok
to apply the change to the server. If this change is done at the server level, and the
change is propagated to all publishing points, all publishing points will allow push without
authentication.
T To Create Pull Publishing Points:
Create a broadcast publishing point on the server and use the WM Appliance's
HTTP URL
as
the source for the publishing point. When you start the publishing point it pulls the stream
from the appliance and you can see the server listed in the client table on the VBrick's Status:
Server Status > Encoder Details page in IWS. You can optionally enable the
Start publishing
point when first client connects
feature in the publishing point's general properties to have
the server wait for a client to connect before it starts the pull from the appliance.
The Windows Media Server must have the HTTP control protocol enabled to accept a push.
Go to
Server Properties
and select
Control Protocol
in the left pane and in the right pane
enable
WMS HTTP Server Control Protocol
to enable HTTP Control Protocol on your
server. The HTTP control protocol uses port 80 by default so make sure you do not have
other services running that also use that port. Also, the
WMS Negotiate Authentication
must
be enabled at the server or Publishing Point level.
Creating Publishing Points on Helix Universal Servers
The RealNetworks Helix Universal Server allows both Push and Pull from a Microsoft
Windows Media encoder and auto-detects for the source method. Currently, only non-
authenticated push publishing points are currently supported by the VBrick WM Appliance
for the Real Helix Universal Server.
Creating Non-Authenticated Push Publishing Points
Using the Helix Administrator interface in the Helix Server, login and on the left pane click
on
Broadcasting
and then click
Windows Media Encoding
. The Windows Media Sources
pane lists all the publishing points that are configured. Note that Helix does not separate Push