VBrick Systems VBRICK APPLIANCE VB6000 - Manual (Page 127)

Diagnostics
VBrick WM Appliance Admin Guide 117
Diagnostics: Hard Drive
T To run Check Disk:
1. Go to
Configuration: System > General
.
2. Set the
Configured Operational Mode
to
Diagnostics
. (After you press
Apply
, the
appliance will reboot. Wait until the front panel displays "Diagnostic Mode.")
3. Go to
Diagnostic: Hard Drive
and click
Begin Edit
.
4. Click
Start
to run the utility. (Note that the
Start
button is only shown in Diagnostic
Mode.
5. Click
Refresh
to see the results.
6. When done, reset
Configured Operational Mode
to
Run
.
Hard Drive Format Use carefully. Removes all content and reformats the hard drive.
Check Disk Runs the Check Disk utility. You must be in Diagnostic Mode to
start Check Disk. See below.