Vox Valvetronix ToneLab SE - Manual (Page 47)

AMP TYPE
CABINET
TYPE
PEDAL
MODULA
TION
DELA
Y
REVERB
Amp/Effect
37
5. U-VIBE
Modelled on the famous Univox Uni-Vibe - a phase/vibrato effect that was
designed to simulate a rotating speaker and produces a wonderfully seductive and
“watery” tone. Interestingly enough, the guy responsible for this great pedal is also
responsible for the birth of the remarkable Valve Reactor Technology used in the
power amp of your ToneLabSE.
HINT: If you assign Speed to be controlled by an expression pedal, you’ll be able to
control the vibrato speed just like on a Uni-Vibe.
6. BLK/ORG PHASE (B/O PHAS)
This models three models of phaser; a wide-range four-stage phaser that was
made in Denmark and packaged in a black box, a popular four-stage phaser that
came in a banana-colored box, and a mild-sounding ten-stage phaser that was
likewise banana-colored. Use the TYPE knob to select the model.
7. OCTAVE
This effect generates a note one or two octaves lower than the one you’re playing,
adding thickness and “weight” to single note lines.
[3] “ATTACK” 1.0...10.0 Adjusts the Auto Wah’s response speed.
[5] “TYPE” 847, 848 Selects either V847 or V848 Clyde McCoy model as
the wah type
[6] “ORDER” PrE(PRE),
PoS(POST) Selects the connection order. PRE/POST connects
the wah before/after the Amp Model.
[1] “SPEED” 1.00...10.00 [Hz] Adjusts the speed of the Uni-Vibe effect.
[2] “DEPTH” 0.0...10.0
Adjusts the depth of the Uni-Vibe effect.
[3] “MIX” 0.0...10.0 Adjusts the mixture of direct sound and vibrato.
[1] “SPEED” 0.100...10.00 [Hz] Adjusts the modulation speed.
[2] “DEPTH” 0.0...10.0*
Adjusts the modulation depth.
[3] “RESO” 0.0...10.0 Adjusts the amount of resonance.
[4] “MANUAL” 1.0...10.0* Adjusts the center frequency of the sweep. MAN-
UAL has no effect if DEPTH is set to 10.
[5] “TYPE” bL, Or1, Or2 Selects the type of phaser.
bL: Danish four-stage phaser with a wide range.
Or1: Popular four-stage phaser in a banana-col-
ored box.
Or2: Sophisticated-sounding ten-stage phaser in
a banana-colored box.
[6] “ORDER” PrE (PRE),
PoS (POST)
Selects the connection order. PRE/POST places
the effect before or after the AMP MODEL.
[1] “DIRECT” 0.0...10.0 Adjusts the level of the original note.
[2] “1OCTAVE” 0.0...10.0 Adjusts the mix level of the note one octave below.
[3] “2OCTAVE” 0.0...10.0 Adjusts the mix level of the note two octaves below.