Vidikron Vision 20 - Manual (Page 30)

English
Basic Operation
29
Basic Operation
Turning on the Power
■ The Power LED lights orange when power is applied and the power switch is turned
on.
■ Press and hold the ON key on the remote control or the Power key on the projector
for ONE second to turn on the unit. The POWER LED will blink orange during
warm up period, then light solid green.
■ " Searching…." will be displayed on the screen before the projector identifies the
input signal. This message will remain on the screen until a valid signal is detected.
■ If an incompatible input signal exceeds the range of the projector a "Not supportive
timing" message will be displayed on the screen. This message will remain on the
screen until you change the input signal.