Uniden 248 - Manual (Page 9)

G E T T I N G S T A R T E D [ 7 ]
GETTING
STARTED
C o n n e c t t h e b a s e u n i t
If you want to install the base unit on the
wall, see page 9.
1 Connect the telephone line cord to the
TEL LINE jack and to a telephone outlet.
2 Connect the AC adapter to the DC IN 9V
jack and to a standard 120V AC
wall outlet.
3 Set the base unit on a desk or tabletop and
place the handset on the base unit.
Then raise the antenna to a vertical position.
C h o o s e t h e d i a l i n g m o d e
Depending on your dialing system, set the PULSE-TONE switch as follows:
If you aren’t sure of your dialing system
Make a trial call with the PULSE-TONE switch set to
TONE .
If the call connects, leave the switch as is; otherwise, set to PULSE .
• Place the power
cord so it does not
create a trip
hazard or where it
could become
chafed and create
a fire or electrical
hazard.
To AC outlet
To telephone outlet
To TEL LINE
To DC IN 9V
AC adapter
(supplied)
Telephone line cord
(supplied)
1
2
Route the cord.
• Use only the
supplied AD-312 AC
adapter. Do not
use any other AC
adapter.
• Place the base
unit close to the
AC outlet so that
you can unplug
the AC adaptor
easily.
Modular
If your telephone outlet isn’t modular, contact
your telephone company for assistance.
PULSE TONE
If your dialing system is Set the switch to
Tone TONE
Pulse PULSE
TRU248_2.4GHz_OM 7/26/00 1:11 PM Page 7