Uniden 248 User Manual
Page 44

[ 42 ]
T H E I N T E G R A T E D A N S W E R I N G D E V I C E
R e m o t e a c c e s s a w a y f r o m h o m e
You can operate your answering system from a remote location using any touch-tone telephone.
Use this function to check for recorded messages, to play or delete messages, even to record a new
outgoing message, and to monitor sounds in the room.
1
Call your telephone number.
2
While the greeting message is played, press
#
and your PIN code.
If the answering system is off, let it ring 10 times until the greeting message is played. Then,
press
#
and your PIN code.
3
The answering system announces the time and day stamp and the number of messages stored
in memory. Then the message playback automatically begins.
4 You may continue to listen to your message, or you may select a command from the
following chart.
Command
Function
#
then
1
Repeat a message
#
then
2
Playing your messages
#
then
3
Skipping a message
#
then
4
Deleting a message
#
then
5
Stop message playback
#
then
6
Answering system on
#
then
7
Voice memo record/stop (up to 4 minutes recording time)
#
then
8
Greeting message record/stop
#
then
9
Answer system off
#
then
*
Room monitor
5
After all of your messages have played, or the playback time exceeds 4 minutes, you will hear
that the intermittent beeps indicating that the system is in the command waiting mode. You
may enter another command at this time from the chart above.
6 When you finish, hang up to exit the system.
The answering system automatically returns to standby.
• During the remote
operation,
rC
displays on the
base.
• You must enter a
command within
15 seconds of
entering command
waiting mode or
the answering
system
automatically
hangs up and
returns to standby.
• The system will
only playback
messages for four
minutes and then
it returns to
command waiting
mode. To continue
playing your
message, press
#
then 2 again
within 15 seconds.
TRU248_2.4GHz_OM 7/26/00 1:12 PM Page 42