Uniden 248 - Manual (Page 12)

I N S T A L L I N G T H E H A N D S E T B A T T E R Y P A C K
Charge the battery pack for at least 15-20 hours before you start using
your phone.
1 Press in on the battery cover release and slide the cover down until
it comes off.
2 Connect the battery pack connector with the correct polarity (black
and red wires), then insert the battery pack into the battery
compartment.
3 Slide the battery cover forward until it snaps into place.
4 Place the handset on the base.
5 Make sure that the “ status ” LED lights. If the LED doesn’t light,
check to see that the AC adapter is plugged in and that the handset
makes good contact with the base charging contacts.
[ 10 ] G E T T I N G S T A R T E D
Use only the Uniden Battery (BT-905) supplied with
your phone.
TRU248_2.4GHz_OM 7/26/00 1:11 PM Page 10