Uniden 248 - Manual (Page 10)

M O U N T I N G T H E B A S E U N I T O N A W A L L
S t a n d a r d w a l l p l a t e m o u n t i n g
This phone can be mounted on any standard telephone wall plate.
1 Snap the wall mount adapter into the notches on the base.
2 Plug the telephone line cord to the TEL LINE jack and the AC
adapter to the DC IN 9V jack.
3 Plug the telephone line cord into the telephone outlet.
4 Wrap the AC adapter cord inside the molded wiring channel.
Then wrap the cord around the strain relief notch.
5 Plug the AC adapter into a standard 120V AC wall outlet.
6 Raise the antenna to a vertical position.
7 Align the mounting slots on the base with the mounting posts
on the wall. Push in and down until the phone is firmly seated.
8 On the base unit, pull the handset retainer out of the slot.
Rotate it clockwise 180 degrees.
9 Flip the retainer from front to back. Slide it back into the slot
so that the lip of the retainer is up and is down. The
retainer holds the handset in place.
[ 8 ] G E T T I N G S T A R T E D
1
2 - 7
8, 9
If you have wall
mounted the base,
you must remove
the beltclip to
charge the handset
facing forward.
TRU248_2.4GHz_OM 7/26/00 1:11 PM Page 8