Uniden 248 User Manual
Page 40

[ 38 ]
T H E I N T E G R A T E D A N S W E R I N G D E V I C E
S e l e c t i n g t h e m e s s a g e r e c o r d t i m e
You can set your answering system to record messages up to one or four minutes long.
One minute option:
move the
REC TIME
switch to
1
.
Four minutes option:
move the
REC TIME
switch to
4
.
▼
Announce only feature:
The announce only feature plays an outgoing message, but it will not allow the caller to leave a
message. Move the
REC TIME
switch to the
ANN
position.
The message counter LED displays “
A
” when system is on standby.
Prerecorded outgoing message for Announce only feature is:
“Hello, no one is available to take your call.” (twice)
S e l e c t i n g a P I N c o d e
To play your messages from a remote location, you will need to enter a two-digit Personal
Identification Number (PIN) code (00-99). To select a PIN, perform the following steps.
1
On the base, press and hold
until a beep sounds and the LED displays
00
.
2
To set the first number, press
or
repeatedly to scroll from 0 to 9. When
the desired number appears in the display, press
.
3
To set the second number, press
or
to scroll from 0 to 9. When the
desired number appears in the display, press
. Then the entered PIN code is announced.
repeat
skip
repeat
skip
Holding
or
to scroll
through numbers on
the display.
repeat
skip
TRU248_2.4GHz_OM 7/26/00 1:12 PM Page 38