Uniden DCT7585 - Manual (Page 67)

66
The FCC Wants You To Know
This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the bottom of this
equipment is a label that contains, among other information, a
product identifier in the format US: AAAEQ##TXXXX. If
requested, this number must be provided to the telephone
company.
An applicable Universal Service Order Codes (USOC)
certification for the jacks used in this equipment is provided
(i.e., RJ11C) in the packaging with each piece of approved
terminal equipment. A plug and jack used to connect this
equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone cord and modular
plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant.
See installation instructions for details.
The REN is used to determine the number of devices that may
be connected to a telephone line. Excessive RENs on a
telephone line may result in the devices not ringing in response
to an incoming call. In most but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of
devices that may be connected to a line, as determined by the
total RENs, contact the telephone provider. For products
approved after July 23, 2001, the REN for this product is part of
the product identifier that has the format US:AAAEQ##TXXXX.
The digits represented by ## are the REN without a decimal
point (e.g., 03 is a REN of 0.3). For earlier products, the REN is
separately shown on the label.
If this equipment causes harm to the telephone network, the
telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance
notice isn’t practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised of your
right to file a complaint with the FCC if you believe it is
necessary. The telephone company may make changes in its
facilities, equipment, operations or procedures that could affect
the operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted service.
Please follow instructions for repairing, if any (e.g. battery
replacement section); otherwise do not substitute or repair any
parts of the device except as specified in this manual.
Connection to party line service is subject to state tariffs.
Contact the state public utility commission, public service
commission or corporation commission for information. This
equipment is hearing aid compatible.
Should you experience trouble with this equipment, please
contact Uniden customer service at 800-297-1023. If the
equipment is causing harm to the telephone network, the
telephone company may request that you disconnect the
equipment until the problem is resolved.
NOTICE: According to telephone company reports, AC
electrical surges, typically resulting from lightning strikes, are
very destructive to telephone equipment connected to AC
power sources. To minimize damage from these types of
surges, a surge arrestor is recommended.
Changes or modifications to this product not expressly
approved by Uniden, or operation of this product in any way
other than as detailed by the owner’s manual, could void your
authority to operate this product.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation. Privacy of communications
may not be ensured when using this phone.
To insure the safety of users, the FCC has established criteria
for the amount of radio frequency energy various products may