Uniden DCT7585 - Manual (Page 47)

46
From the base From the handset
1. Press [menu/clock] six times.
2. The current setting ("E" English, "F" French, or "S" Spanish)
appears on the base, and it is announced ("English" English,
"Français" French, or "Español" Spanish).
3. Press [ /select] or [ /select] to select the language.
4. Press [set]. A confirmation tone sounds, and the system
announces the new setting in the selected language.
1. Press [menu/clear]. Select ANSW.
SETUP, and then the LANGUAGE
submenu.
2. Move the cursor to choose ENGLISH,
FRANÇAIS (French), or ESPAÑOL
(Spanish).
3. Press [select/ ] . You will hear a
confirmation tone.
Setting the Number of Rings
The ring time setting allows you to set the number of rings the caller hears before your answering system plays the
outgoing message. You can set the ring time to answer after two, four, or six rings. If you enable the Toll Saver (TS)
setting, the answering system picks up after two rings if you have new messages, and after four rings if there are
none. This way, if you make a long distance call to check your messages, you can hang up after the second ring to
avoid long distance billing charges.
From the base From the handset
1. Press [menu/clock] three times. The base displays
the current number of rings (2, 4, 6, or TS for toll
saver) and announces the setting.
2. Press [ /select] or [ /select] until the desired
ring time appears.
3. Press [set]. A confirmation tone sounds, and the
system announces the new ring time.
1. Press [menu/clear]. Select the ANSW.
SETUP menu, and then the RING TIME
submenu.
2. Move the cursor to select a ring time (TOLL
SAVER, 2 TIMES, 4 TIMES, or 6 TIMES).
3. Press [select/ ] . You will hear a
confirmation tone.