Uniden BR330T - Manual (Page 88)

88
Notes:
• The scanner defaults to AFS (agency, fleet,
subfleet) format - the format used in most EDACS
systems.
• See “EDACS Trunking” on Page 27 for more
information about the AFS format.
Setting System Attenuation
(Trunked Systems Only)
Program System
Select the system
Set Attenuator
This setting controls whether the attenuator will be on
or off for the current system. Select your setting then
press E.
Off - the attenuator is off.
On - system frequencies are attenuated by about 18 dB.
Notes:
• Even if ATT appears, attenuation might not work if
the bar antenna is turned on and the tuned
frequency is from 0.1 to 1.7 MHz.
• Turn on this setting if you are near strong signal
sources. Attenuation can help reduce interference
and desensitization that strong signals create.
• You can also turn this setting on or off by holding
on a trunked system, then pressing + E.
Deleting Systems
Program System
Select the system
Delete System
The scanner prompts you to confirm deletion.
To confirm, press E. To cancel, press .
Menu
Func
Menu