Uniden BR330T - Manual (Page 58)

58
Then connect the other end of the cables together
using the null modem connector and gender changer.
Then set the scanner containing the programming you
want to transfer as the master scanner, then set the
other scanner as the slave scanner.
(Master scanner) Clone Master Press SCAN Key
(Slave scanner) Clone Slave Press SCAN Key
When you are ready to clone the scanner, press
on the slave scanner first, then on the master scanner.
The master scanner checks the connection between the
two scanners, then transfers its data to the slave scanner.
When the transfer is complete, Complete appears on
both scanners. If the transfer did not work, Error
appears on the master scanner.
On-Air Cloning
You can clone (copy) data from a PC to a BR330T
scanner. This is useful if you want to quickly program
20 or more BR330T scanners at the same time.
Note: On-air cloning is practical if you are
programming more than 10 scanners at the same
time. Otherwise, we recommend you use wired
programming.
Xfer Information
On-Air Clone
• Start Cloning Start on-air cloning.
• Set Frequency Lets you set the frequency where
your scanner receives the cloning broadcast.
• Set Modulation Lets you set the cloning
broadcast’s modulation type.
To clone (copy) data from a PC to the scanner, you
need a transceiver, a PC that has an audio input, and
a cable to connect your PC’s sound card to the
Scan
Scan
Scan
Menu