Uniden BR330T - Manual (Page 121)

121
Using Weather Alert (SAME)
the following settings and press E
YES
to select and
modify the selected settings:
• Edit Name - Sets the name for the selected tone-
out setting.
• Set Frequency — Sets the tone-outs RF fre-
quency parameters.
Edit Frequency — Enter the desired fre-
quency that the scanner should monitor for the
tone-out.
Set Modulation — Set the modulation type
for the paging signal.
Auto —The scanner uses the default modu-
lation for the frequency band. If the default
modulation is AM or WFM, the modulation
operates as FM.
FM — The scanner uses FM for the frequency
band. This is the default setting.
NFM — The scanner uses NFM modulation.
Set Attenuaton — Turn the scroll control to
select On or Off.
• Set Tone — Sets the audio tone frequency for
the page.
Edit Tone A — Set the audio frequency
for Tone A
Edit Tone B — Set the audio frequency
for Tone B
Notes:
• For two-tone pages, enter a value for A and B.
• For one-tone pages using short tones of less
than 3.75 seconds, enter the tone value for A,
and 0 (zero) for B.
Using Tone-Out