Uniden DSS 2475 - Manual (Page 71)

[ 65 ]
Symptom Suggestion
The handset or the base can’t • Make sure that more than 3 handsets (or 2 handsets when the base is used
join the conversation. for the conference) are not in use.
• When recording a conversation, the 2nd handset (or the base) cannot join
the conversation.
The answering system • Make sure the base unit is plugged in.
does not work. • Make sure that the answering system is turned On.
• Make sure that the message record time is not set to Announce only
(see page 47).
Messages are incomplete. • The incoming messages may be too long. Remind callers to leave a
brief message.
• The memory may be full. Delete some or all of the saved messages.
After a power failure, the • Record your greeting again. The default message should remain.
outgoing message is deleted.
No sound on the base unit
• Adjust the speaker volume on the base unit.
speaker during call monitoring • Make sure the call screen feature is set to On.
or message playback.
Cannot access remote call-in
• Make sure you are using the correct PIN number.
features from another • Make sure that the touch-tone phone you’re using can transmit the tone
touch-tone phone. for at least two seconds. If it cannot, you may have to use another phone
to access your phone.
Time stamp cannot be heard. • Make sure you have set the time (see “Setting Day and Time” on page 21
or “Setting the Time” on page 45).
If you still have a problem. • Check our web site for the latest information and frequently asked questions.
www.uniden.com.au
www.uniden.co.nz
UP308BH (DSS2465) ENG OM 12/28/04 8:27 AM Page 65