Uniden DSS 2475 - Manual (Page 52)

[ 46 ]
Setting the ring time
The ring time setting allows you to set the number of rings the caller hears before your
answering system plays the outgoing message. You can set the ring time to answer after
four, six, or nine rings. Setting “TS” (Toll Saver), the answering system picks up after
six rings if you have new messages, and after nine rings if there are none. This way, if
you make a long distance call to check your messages, you can hang up after the sixth
ring to avoid billing charges.
1) Press
three times.
The current ring time setting (“ ” 4, “ ” 6, “ ” 9 or “ ” Toll saver) appears on
the base and it is announced.
2) Press /SELECT or /SELECT until the desired ring time appears.
3) Press to select the new ring time.
A confirmation tone sounds, the system announces the new ring time.
Selecting the message record time
You have three record time options. The options “ 1 minute” or “4 minutes” set the
duration for recording the incoming messages. “ Announce only” answers the call
with the preset greeting or your personal greeting but prevents the caller from
leaving a message.
1) Press four times.
The current recording time (“ ” 1 minute, “ ” 4 minutes, “ ” Announce only No
recording) appears on the base and it is announced.
2) Press /SELECT or /SELECT until the desired message record time appears.
3) Press to select the new recording time.
A confirmation tone sounds, the system announces the new record time.
UP308BH (DSS2465) ENG OM 12/28/04 8:26 AM Page 46