Uniden DSS 2475 User Manual
Page 49
[ 43 ]
Choosing between the two outgoing messages
When the phone is in the standby mode, press
. Press
again when
the outgoing message is played. Each time
is pressed, the outgoing message
is switched between the pre-recorded and the personal outgoing message.
Deleting an outgoing message
To delete the personal outgoing message, press
while the message is playing.
The system announces “Greeting has been deleted”.
Setting the base ringer volume
You have four ringer volume options. One allows you to turn the base ringer off.
The other three are volume levels.
1) When the phone is in the standby mode, press
/
▲
or
▼
. You hear the
ringer at the current volume level (“ ” High, “ ” Medium, “ ” Low, or “ ” Off)
(if you set the base ringer volume to off “Ringer Off” is announced), and it appears
on the base.
2) Press
/
▲
or
▼
repeatedly until the desired ringer volume appears. You
will hear a ringer at the selected volume level. The system returns to the standby
mode.
You can also set the base ringer volume while the phone is ringing. Press
/
▲
or
▼
repeatedly to select the desired ringer volume.
• If an outside call is
received during this
operation, the
operation is canceled.
• If you press
/
▲
in the maximum
volume level (3) or
/
▼
in
the ringer off (0), you
will hear a beep.
UP308BH (DSS2465) ENG OM 12/28/04 8:25 AM Page 43