Uniden WDSS 5315 - Manual (Page 21)

20
Setting up Voice Mail
If you subscribe to a voice mail service, you can use your phone to access your voice mailbox. The new message
LED flashes whenever you have messages waiting in your voice mailbox. If you have programmed your access
number into your phone, you can simply press [select/ ] to access your voice mail. When you subscribe to the
service, your voice mail provider provides you with the access number and the required voice mail signaling tone.
Programming One-Touch Voice Mail Access
You can program your voice mail access number to the Voice Mail key on each handset so you can get your
messages at the touch of a button. Your voice mail service provider will supply you with the access number.
This number may be simply a phone number.
To edit the voice mail number, follow the steps below:
Press [menu/clear].
Move the cursor to HANDSET SETUP menu and press [select/ ].
Move the cursor to EDIT VOICE MAIL and press [select/ ].
Enter your personal access number (up to 20 digits).
If you need to have the phone wait before sending the next digits, press
[redial/pause] to insert a two-second
pause in the dialing sequence. For a longer pause, press [redial/pause] multiple times. A appears in the
display each time you press [redial/pause] and each pause counts as one digit.
Press [select/ ] when you are finished.
Resetting the Voice Message Waiting Indicator
When you receive a new voice mail message, the LED on the top of the handset flashes. In the event your message
alert tone gets out of sync with your phone company’s voice messaging system, you can reset back to its original
“no messages waiting” state. To reset, press and hold [find hs] on the base for 5 seconds. A beep sounds and the
message alert tone is reset.
)
2)
3)
4)
5)
6)
'FKV8AOCKN0Q 'FKV8AOCKN0Q