Uniden WDSS 5315 - Manual (Page 17)

6
Connecting the Base and Charging the Handset
Connect the AC adapter to the DC IN 9V jack.
CAUTION: To avoid risk of fire and shock, only use the Uniden
AAD-04S AC adapter.
Connect the AC adapter to a standard 240V AC wall outlet.
DO NOT use an AC outlet controlled by a wall switch.
Place the handset in the base with the LCD screen facing forward.
Make sure that the charge LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in and the
handset makes good contact with the charging contacts.
Charge your handset at least 5 to 20 hours before plugging into
the phone line.
Installing the Belt Clip
Line up the holes on each side of the handset. To attach the belt clip, insert into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the tabs from
the holes.
)
2)
3)
4)
5)
To AC outlet
To DC IN 9V
AC adapter (supplied)
To AC outlet
To DC IN 9V
AC adapter (supplied)