Uniden DECT2088 Series - Manual (Page 47)

45 45 46 46
Setting Up the
Answering System Setting the Day & Time
If.you.do.not.set.the.clock.on.your.answering.system,.your.messages.may.not.have.the.correct.time.and.day.stamp..
Press.[Menu/Select].
Move.the.cursor.to.DAY.&.TIME.and.press.[Menu/Select].
Use.[ ].and.[ ].to.select.the.day.of.the.week,.and.press.[Menu/Select].
Use.the.number.keypad.([0].through.[9]).to.enter.the.hour.and.minutes.
Use.[ ].and.[ ].to.select.AM.or.PM,.and.press.[Menu/Select]
. You hear a confirmation tone.
Notes:.•.You.can.set.the.day.and.time.from.the.handset,.but.the.day.and.time.do.not.appear.on.the.handset.display..
. •.If.the.power.goes.out.on.the.base,.the.day.and.time.setting.will.be.erased,.and.you.must.set.the.clock.
again.”
Setting the Record Time (or Announce only)
You.can.choose.how.long.callers.have.to.record.a.message..Set.the.record.time.to..MINUTE.or.4.MINUTES.to.limit.
the.time.for.incoming.messages..If.you.set.the.record.time.to.ANNOUNCE.ONLY,.the.answering.system.answers.the.
call.but.prevents.callers.from.leaving.a.message.
Press.[Menu/Select]..
Select.the.ANSW..SETUP.menu,.and.then.the.RECORD.TIME.submenu.
Move.the.cursor.to.select.a.record.time.(.MINUTE,.4.MINUTES,.or.ANNOUNCE.ONLY).
Press.[Menu/Select]
. You will hear a confirmation tone.
While.your.answering.system.is.set.to.ANNOUNCE.ONLY,.the.message counter.on.the.base.LCD.displays.“A.”.If.
you.are.using.the.prerecorded.greeting,.the.system.automatically.switches.to.the.following.message:.“Hello,.no.one.
is.available.to.take.your.call..Please.call.again.”.If.you.are.using.a.personal.greeting,.the.system.continues.to.use.
that.greeting.
)
2)
3)
4)
5)
)
2)
3)
4)
UC517BH(DECT2088) book OM 2.indb46 46 1/9/2008 11:08:02 AM