Uniden DCX 640 - Manual (Page 29)

G E T T I N G S T A R T E D [ 2 7 ] w w w . u n i d e n . c o m
Setting the Area Code
1) Enter the Global Setup menu, and then the Area Code
submenu (see "Entering the Menu" on page 21).
2) Press the number keypad (0-9) to enter a 3-digit
area code.
3) Press select/
. You will hear a confirmation tone.
Setting the Dial Mode
1) Enter the Global Setup menu, and then the Dial Mode
submenu (see "Entering the Menu" on page 21).
2) Press ring/vol/ ∧ or ring/vol/∨ to select T o ne or Pu l se
(the initial setting is Tone).
3) Press select/
. You will hear a confirmation tone.
• If you are not sure of your dialing system, set the unit to tone dialing. Make a trial call.
If the call connects, leave the setting as is, otherwise set the unit to pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones in
certain situations during a call, you may Switch Over to tone dialing (refer to “Tone
Dialing Switch-over” on page 33).
Copy Phonebook
1) Enter the Global Setup menu, and then the Copy Phonebook
submenu (see “Entering the Menu" on page 21).
2) Press ring/vol/ ∧ or ring/vol/∨ to choose On e M em o ry or
A l l M em o ry , and then press select/
.
If you choose A l l M em or y , go to step 4.
3) Press ring/vol/ ∧ or ring/vol/∨, or the number keypad (0-9) to select the phonebook
location you want to export and then press select/
.
4) Press ring/vol/ ∧ or ring/vol/∨ to select the handset to which you want transfer the
phonebook locations, and then press select/
.
# T G C % Q F G
㨫 A A
& K C N / Q F G
6 Q P G
2 W N U G
% Q R [ 2 J Q P G D Q Q M
1 P G / G O Q T [
# N N / G O Q T [ Z Z Z
• When the area code has
already been stored in
memory, the stored area
code will be displayed.
To change it, use menu/del
and number keys to enter the
new area code.
•If you receive a call or setup
the Global Setup menu,
the transfer will be canceled.
• If an error occurs, the
phonebook locations
transferred before the error
were stored in the receiving
handset. Unavailable
appears on the display.
•When the memory of the
receiving handset is full,
Not enough memory
in Receiving
Handset appears. You
cannot transfer the phone
book location.
note
GETTING ST
ARTED