Uniden TRAX430 - Manual (Page 24)

Page 4
How Do I Put It in My Car?
When you decide where you want to mount the disk, hold the
suction cup in that spot and set the angle and position of the
bracket (just like you would for mounting on your windshield).
Clean the spot to remove any wax, grease, protecterants, etc.
Carefully peel the protective sheet
from the bottom of the anchor disk to
expose the glue.
Hold the disk
exactly above the spot where
you want to glue it down. (Remember, the
glue is designed to be permanent!)
Press the disk firmly against the surface. Push down along the
edges, too, so that every part of the disk makes good contact
with the surface.
Before you install the windshield
mount, gently tug on the disk to
make sure it’s secure.
Press the suction cup flat into the
anchor disk, then push the suction
latch down (towards the suction
cup) to lock it into place.
1)
2)
3)
4)
5)
6)
7)
Flip the latch
down towards
the suction cup
Flip the latch
down towards
the suction cup