Uniden TRAX430 - Manual (Page 23)

Page
How Do I Put It in My Car?
R
emovinG The WindShield mounT
When you release the suction latch, make sure you’re
holding or somehow supporting the device.
Lift the suction latch and use the plastic pull tab to pull the suction
cup off of the glass.
Mounting on a flat surface
If you want to put the device somewhere other than your windshield
(or anywhere the suction cup won’t stick), you can use the anchor
disk. Once you glue the anchor disk down, the windshield mount
installs inside the disk just like it does on glass.
When you’re deciding where to put the anchor disk, here are some
things to keep in mind:
The surface should be as flat as possible. If the disk is upside
down or at a sharp angle, it might not hold the device’s weight.
The surface should be
as smooth as possible. If the surface
texture is too rough, the glue may not stick as well.
The anchor disk will stick permanently on most surfaces. If
you try to remove the disk, you might damage the surface.
Don’t peel off the protective sheet until you’re ready to install
the disk. Once you expose the glue, you can’t stop easily.
►
►
►
►