Uniden DCT 748 - Manual (Page 55)

T H E I N T E G R A T E D T E L E P H O N E A N S W E R I N G D E V I C E [ 5 4 ] w w w . u n i d e n . c o m
Using Your Answering System
The new message LED on the handset and base blink when you
have new messages in your answering system. The LED stops
flashing when all new messages are played back.
The answering system is designed to play your new messages first.
After you play all your new messages, you can then play your old
messages.
Playing your messages
1) When the base is in standby mode, press .
The system announces the number of new and old
messages. The time and day that each message was
received is announced after the message is played.
The message number is announced in the begining
of each message.
2) When all new messages have been played, you hear a confirmation tone, and the
system announces "End of messages." The system returns to standby. After you
have reviewed your new messages, you can play your old messages by pressing
again. Once you have listened to a new message, it then becomes an old
message. The old messages will be played in the order in which they were
received.
•When the answering
system is full, you will
hear "The memory is
full. Please erase your
messages." and the
message LED will blink
quickly. You should
delete some messages
so that the system can
record new messages.
•The time stamp will
not be heard until you
have set the time.
note
T
H
E INT
E
GRA
T
ED TE
LEPHONE
A
N
S
W
ERI
NG DEV
ICE
UP720.book Page 54 Tuesday, July 6, 2004 10:55 AM