Uniden DCT 748 - Manual (Page 39)

P H O N E B O O K [ 3 8 ] w w w . u n i d e n . c o m
9) Press select/ /audio tone. You will hear a
confirmation tone, and Do n e! appears in the display.
Storing Caller ID Messages in the Phonebook
Messages shown in the Caller ID list (see page 45) can be stored in the phonebook.
The phone number and name of the party on the Caller ID list can be stored in
memory.
1) When the phone is in standby mode, select the Caller ID message to be stored.
2) Press select/
/audio tone. S to r e/ Ed i t N am e appears.
If the Caller ID message is already stored in memory, you will hear a beep and
T h is da t a is al r ea d y st o re d !! appears. The number will not be stored.
3) To complete the setting, follow the steps 4-9 in “Storing and Editing Phone
Numbers, Names, Distinctive Rings and Speed Dial” on page 35.
Storing a Redial Record
1)With the phone in standby mode, press pause/redial.
2) Press pause/redial repeatedly to display the number to be stored.
3) Press select/
/audio tone. S to r e/ Ed i t N am e appears.
4) To complete the setting, follow the steps 4-9 in “Storing and Editing Phone
Numbers, Names, Distinctive Rings and Speed Dial” on page 35.
/ Q X K G U
㨰 $ G G V J Q X G P 5 2 &
•If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
•If the Caller ID
message was received
as a private/unknown
number, or the
message does not have
the number, you
cannot store the
message in the
phonebook. If it was
received as private/
unknown name, the
message will be stored
as .
•Even if all 100 memory
locations are full, the
message will be stored
in the phonebook.
However, the message
will be erased from the
Caller ID list.
note
P
H
ONE
B
OOK
UP720.book Page 38 Tuesday, July 6, 2004 10:55 AM