Uniden DCT 748 - Manual (Page 33)

B A S I C S [ 3 2 ] w w w . u n i d e n . c o m
Tone Dialing Switch-over
If your telephone company requires pulse dialing, you can
switch-over to tone dialing after the call connects. This
feature is useful when you need tone dialing to use any
automated menu systems, such as telephone bank tellers,
telephone prescription refills, customer support menus,
etc.
If your phone is set to pulse dialing mode, make your call
normally. Once your call connects, press the
* /tone/
key. Any digits you enter from then on will be sent as tone digits. When this
particular call ends, the phone automatically returns to pulse dialing mode.
Traveling Out of Range
During a call, as you begin to move your handset too far from your base unit, noise
may increase. If you pass the range limits of the base unit, you will hear a beep and
see
Ou t of Ra nge on the display, and then the handset returns to standby mode. You
may return to the call if you move your handset within the range limits of the base
and press talk/flash or
within 30 seconds.
BA
SI
C
S
UP720.book Page 32 Tuesday, July 6, 2004 10:55 AM