beautypg.com

Getting started, Installing your phone – Uniden D2280 User Manual

Page 3

background image

English -

CAUTION! Risk of explosion

if battery is replaced by an

incorrect type! Dispose of used

batteries according to the

instructions. Do not open or

mutilate the battery. Disconnect

the battery before shipping this

product.

For more details, see the

Important Information section.

GETTING STARTED

Installing Your Phone

Charge the Battery

Unpack all handsets,

battery

packs, and

battery

covers. If

you need

to remove

a cover, press in on the notch

and slide the cover down and

off.
Line up the battery connector

with the jack inside the

handset; the connector only fits

one way.
Push the connector in until

it clicks into place; tug gently

on the wires to make sure the

battery is securely connected.
Replace the battery cover and

slide it into place.
Use an AC adapter to connect

the power jack on the base to

1.

2.

3.

4.

5.

a regular indoor (120V AC)

power outlet. Connect any

chargers the same way.
Place a handset in the base with

the display facing forward. If

the display doesn’t light up,

reseat the handset or connect

the base to a different outlet.

For 2 or more handsets, place

each handset in a charger.

Charge all handsets

completely (about 15 hours)

before using.

Connect the Telephone Cord

Use the telephone cord to connect

the

TEL LINE

jack on the base to a

standard telephone wall jack.

Test the Connection

Pick up the handset and press

Talk

. The handset sounds a dial

tone, and the display shows

Talk

.

If you don't hear a dial tone or

the display says

Check Tel Line,

check the connection between

the base and the phone jack.

Make a quick test call. (Press

End

to hang up.)

If you keep hearing a dial tone,

change to pulse dialing.
If there’s a lot of noise, check

for interference (see p. 22).

Test all handsets the same way.

If you can't get a dial tone,

move the handset closer to the

base.

6.

1.

2.

3.