Uniden D2280 - Manual (Page 23)

English -
Answering system problems Possible solutions
The answering system does
not work.
Make sure the answering system is on.
Make sure the base is plugged in.


The system won't record
messages.
See if Record Time is set to Announce
Only .
Delete messages (memory may be full).


A handset can't access the
answering system.
See if another handset is using the
system.
Make sure the phone is in standby.


My outgoing message is gone.
If there was a power failure, re-record
your personal outgoing message.

I can’t hear the base speaker.
Make sure call screening is turned on.
Change the base speaker volume.


Messages are incomplete.
Increase the Record Time .
Delete messages (memory may be full).


The system keeps recording
when I answer on an
extension.
You may have to change the line
mode. Contact Customer Service for
instructions.

Installing a Line Filter or DSL Filter
A telephone line filter or DSL filter prevents services that use the
phone line from causing interference on your phone. To get a line filter,
contact your service provider or look in an electronics store.
Plug the filter into the telephone wall jack and plug the base into the
filter. Make a test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the
adapter & phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset,
wipe it off and use as normal. If you can hear liquid inside the housing:
Remove all compartment covers, and disconnect all cables and
cords.
If liquid is leaking from any vent or hole, turn the phone so that vent
faces down. If not, place the largest vent face down.
1.
2.