Uniden D2280 - Manual (Page 27)

English -
The base must be placed to allow a
minimum of 20 cm (8 inches) between
the antenna and all persons during
normal operation.
The base must not be collocated or
operated in conjunction with any other
antenna or transmitter.
The handset is designed for body-
worn operation and meets FCC RF
exposure guidelines when used with
any belt clip, carrying case, or other
accessory supplied with this product.
(All necessary accessories are included
in the package; any additional or op-
tional accessories are not required for
compliance with the guidelines.) Third
party accessories (unless approved by
the manufacturer) should be avoided as
these might not comply with FCC RF
exposure guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: This equipment meets the
applicable Industry Canada Terminal Industry Canada Terminal
Equipment Technical Specifications.
This is confirmed by the registration
number. The abbreviation IC before
the registration number signifies that
registration was performed based on a
Declaration of Conformity indicat-
ing that Industry Canada technical
specifications were met. It does not
imply that Industry Canada approved
the equipment.
NOTICE: The Ringer Equivalence
Number (REN) for this terminal
equipment is marked on the equip-
ment itself. The REN assigned to
each terminal equipment provides an
indication of the maximum number of
terminals allowed to be connected to
a telephone interface. The termination
on an interface may consist of any
combination of devices subject only
to the requirement that the sum of the
Ringer Equivalence Numbers of all the
devices does not exceed 5.



Radio equipment
The term IC before the radio certi-
fication number only signifies that
Industry Canada technical specifica-
tions were met. Operation is subject
to the following two conditions: (1)
this device may not cause interference,
and (2) this device must accept any
interference, including interference
that may cause undesired operation
of the device. "Privacy of communica-
tions may not be ensured when using
this telephone".
1-Year Limited Warranty
Evidence of original purchase is
required for warranty service.
WARRANTOR: UNIDEN AMERICA
CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden
warrants, for one year, to the original
retail owner, this Uniden Product to
be free from defects in materials and
craftsmanship with only the limita-
tions or exclusions set out below.
WARRANTY DURATION: This
warranty to the original user shall
terminate and be of no further effect
12 months after the date of original
retail sale. The warranty is invalid if
the Product is (A) damaged or not
maintained as reasonable or necessary,
(B) modified, altered, or used as part of
any conversion kits, subassemblies, or
any configurations not sold by Uniden,
(C) improperly installed, (D) serviced
or repaired by someone other than an
authorized Uniden service center for a
defect or malfunction covered by this
warranty, (E) used in any conjunction
with equipment or parts or as part of
any system not manufactured by Un-
iden, or (F) installed or programmed
by anyone other than as detailed by the
owner's manual for this product.
STATEMENT OF REMEDY: In the
event that the product does not con-