Uniden D2280 - Manual (Page 21)

English - 1
Programming a Security Code
With the phone in standby, open the menu; select Ans. Setup , then
select Security Code . Use the number keypad to enter a two-digit
security code ( 01 to 99 ). Press MEnu/sElEcT when you’re finished.
Remember to make a note of your new security code!
Dialing In to Your System
Call your phone number & wait until the system answers. (If the
system is turned off, it answers after 10 rings & sounds a series of
beeps.)
During the greeting or beeps, press
0 and immediately enter your
security code. If you enter it incorrectly 3 times, the system hangs
up and returns to standby.
The system announces the time, the number of messages in
memory, and a help prompt. It beeps to let you know it's waiting for
a command.
When you hear beeping, enter a 2-digit command from the chart.
If you don't
press any
keys for 15
seconds, the
system hangs
up and return
to standby.
IMPORTANT INFORMATION
Solving Problems
If you have any trouble with your phone, check this section first. If you
need help, call our Customer Care Line listed on the front cover.
General problems Possible solutions
No handsets can make or
receive calls.
Check the telephone cord connection.
Disconnect the base AC adapter for a few
minutes; then reconnect it.


A handset can’t make or
receive calls.
Move the handset closer to the base. 

1.
2.
3.
4.

01 Repeat message 05 Stop playback
02 Play message 06 Turn the system on
03 Skip message 09 Turn the system off
04 Delete message 10 Hear help prompts
01 Repeat message 05 Stop playback
02 Play message 06 Turn the system on
03 Skip message 09 Turn the system off
04 Delete message 10 Hear help prompts