Resetting the handset without the base, Changing the digital security code – Uniden DCT758 User Manual

Page 61

When.the.base.information.is.deleted,.the.handset.displays.MODELS.VARY!.CHARGE.HANDSET.ON.THE.

BASE.FOR.REGISTRATION.OR.REFER.TO.OWNER’S.MANUAL.
Re-register.the.handset.to.the.base.(see.

Registering Accessory Handsets.on.page.20)..

If.the.handset.cannot.contact.the.base,.it.will.display.UNAVAILABLE..Make.sure.the.handset.is.in.range.of.the.base.

and.the.base.is.connected.to.power.

Resetting the Handset Without the Base

If.your.original.base.is.not.available.for.some.reason.(for.example,.it.is.lost.or.somehow.incapacitated),.you.can.still.

reset.the.handset.and.use.it.with.another.base.

Press.and.hold.

[ ].and.[#/>].for.at.least.5.seconds.

Move.the.cursor.to.select.REPLACING.BASE.and.then.press.

[select/ ]..REPLACE.BASE.appears.

Move.the.cursor.to.select.YES,.and.then.press.

[select/ ]. You hear a confirmation tone, and the handset

deletes.its.own.base.information.without.contacting.the.base..The.handset.displays.MODELS.VARY!.

CHARGE.HANDSET.ON.THE.BASE.FOR.REGISTRATION.OR.REFER.TO.OWNER’S.MANUAL...
Register.the.handset.to.the.new.base.(see.

Registering Accessory Handsets on.page.20).

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base. Your unit ships from the

manufacturer.with.a.preset.security.code..Resetting.this.code.is.not.normally.necessary..In.the.rare.situation.that.you.

suspect.another.cordless.telephone.is.using.the.same.security.code.or.if.you.are.instructed.to.change.this.code.by.a.

manufacturer’s.Call.Center.Representative,.you.can.change.the.code..To.change.the.digital.security.code:

Reset.the.handset.(see.

Resetting the Handset on.page.59).

Re-register.each.handset.(see.

Registering Accessory Handsets.on.page.20).

.
2.
3.

.
2.