Uniden DCT758 User Manual

Page 27

If.you.select.ALL.MEMORY,.ARE.YOU.SURE?.appears.on.the.display.screen..Move.the.cursor.to.select.YES,.

and.then.press.

[select/ ].

If you select ONE MEMORY, find the phonebook entry you want to transfer and then press

[select/ ].

The.phonebook.entries.will.be.transferred.to.the.designated.handset..During.the.copy.process,.the.receiving.

handset.shows.RECEIVING.and.the.banner.of.the.sending.handset.
When.the.transfer.is.completed,.DONE!.appears.on.the.handset.

Note: If your phonebook contains 100 entries, you cannot store any new phonebook entries. You will

hear a beep, and MEMORY FULL appears on the display. If the selected handset is out of range or

data transfer is canceled, UNAVAILABLE appears in the display. Phonebook listings will not be

transferred.

Programming Base Speed Dial Numbers (Dual Keypad Model Only)

The.dual.keypad.base.can.store.0.speed.dial.numbers,.

[0].to.[9]..Follow.the.steps.below.to.store.new.speed.

dial.numbers.in.the.base..(Handset.speed.dial.numbers.are.stored.as.part.of.a.phonebook.entry..See.

Creating

Phonebook Entries.on.page.22.for.information.on.programming.handset.speed.dial.numbers.)

With.the.phone.in.standby,.press.

[memory].

Use.the.number.keypad.to.enter.the.phone.number;.the.phone.number.can.contain.up.to.20.digits..If.you.

need.the.phone.to.pause.between.digits.when.it’s.dialing.(for.example,.to.enter.an.extension.or.an.access.

code),press.

[redial/pause].to.insert.a.two-second.pause..You.can.also.use.more.than.one.pause.together.if.

two.seconds.is.not.long.enough..Each.pause.counts.as.one.digit.
Press.

[memory].again,.and.then.press.the.number.key.[0].to.[9].where.you.want.to.store.this.phone.number..

You will hear a confirmation tone.

6.
7.

.
2.