Uniden DCT758 - Manual (Page 17)

6
Check.to.make.sure.the.battery.is.fully.charged..(If.you.don’t.see.the.“battery.full”.icon,.check.to.make.sure.
the.battery.is.properly.connected).
Change.the.dial.mode.(instructions.below).
Changing the Dial Mode
Your.phone.can.communicate.with.the.telephone.network.in.two.different.ways:.tone.dialing.or.pulse.dialing..These.
days,.most.phone.networks.use.a.method.called.tone.dialing,.so.your.phone.comes.programmed.for.tone.dialing..If.
your.phone.company.uses.pulse.dialing,.you.will.need.to.change.your.phone’s.dial.mode..If.you.don’t.get.a.dial.tone.
or.can’t.connect.to.the.telephone.network,.please.follow.the.steps.below.to.modify.your.phone’s.settings:
Press. [menu/clear]..Select.the.GLOBAL.SETUP.menu,.and.then.
the.DIAL.MODE.submenu.
Scroll.
[ ].to.select.PULSE.
Press. [select/ ]. You will hear a confirmation tone.
If.you.ever.need.to.change.the.dial.mode.back.to.tone.dialing,.follow.the.
same.procedure,.but.select.TONE.in.step.2.
Installing the Belt Clip
Line.up.the.holes.on.each.side.of.the.handset..To.attach.the.belt.clip,.insert.
into.the.holes.on.each.side.of.the.handset..Press.down.until.it.clicks.
To remove the belt clip,.pull.either.side.of.the.belt.clip.to.release.the.tabs.
from.the.holes.
2.
3.
.
2.
3.
D i a l M o d e
T o n e
P u l s e D i a l M o d e
T o n e
P u l s e