Uniden BEARCAT UBC3500XLT - Manual (Page 34)

34
Locking/Unlocking Channels
Follow these steps to lock out a channel so that it does
not scan even if its system and channel group are
selected.
1. While holding down , rotate the scroll control
to select the system where the channel is stored.
2. Release then press Hold within 2 seconds
to hold on the system.
3. Rotate the scroll control to select the channel you
want to lock or unlock.
4. Press L/O to lock or unlock the channel.
You can also lock out an active channel by pressing
L/O while the scanner is stopped on the channel.
Temporarily Holding On a System
To temporarily hold on a system, press and hold .
To hold on a different system, continue to hold
and rotate the scroll control to select the system.
Normal scanning resumes 2 seconds after you release
.
Holding On a Channel
To hold on a channel, press Hold while the channel is
active. To select a different channel, rotate the scroll
control. If you scroll past the beginning or end of the
current system, the scanner selects channels in the
previous or next system. To resume scanning, press
Scan.
Quick-Storing Channels
1. Hold on an existing channel in any system.
2. Enter the frequency you want to store.
3. To quick-store the channel, press E. Otherwise,
press .
If you enter a frequency then press E, the scanner
stores it in the Qck Save Grp group in a system
Func
Func
Func
Func
Func